Darren
i miei contenuti
Tutti i messaggi
Recensioni
Commenti
risposta
Domande

Tutti i messaggi

Darren 30/10/2018
Mine arrived in very poor condition, both lenses were floating and not secured properly. The 2x 18650's used in mine were generic Chinese cells and had a real capacity of 2000mAh not 2200mAh. On the stock generic cells the runtime on full was respectable at a few hours. I modded mine and upgraded to 2x Sanyo NCR18650GA's which had a very noticeable effect on the runtime. Don't try to do this unless you are comfortable with soldering as it's not a simple or particularly easy job, you will need to spot weld your new cells together and swap over the battery protection and then squeeze everything back into the aluminium body. I did not notice much if any increase in output from changing the wires to a larger AWG or the lower resistance cells, I would assume this is because the stock wires are sufficient and the light is regulated. I did not do any current measurements but going by the output in comparison to another genuine Cree torch I would say it is around 1000 lumens MAX. The heat sinking to the main aluminium body is near enough non existent but the small contact area it does have did not have any thermal compound, I am extremely surprised it runs as well as it does. Overall it's a nice looking light that works well but the actual spec is WAY off, my estimate would be 1000 lumen 5500K 75CRI with a 4000mAh battery which in comparison to the leading brands of bike lights makes this still well worth the money!
XANES DL07 1800LM 2*L2 4400mAh Ricaricabile Batteria Indicatore Luce per Bici
US$36.95 US$38.99
4
raccomandazioni
Commento (1)
Darren 01/12/2018
Nice quality straps!
Cinghia con nastro magico RJX HOBBY per batteria RC
US$8.07 US$8.99
0
raccomandazioni
Commento (0)
Darren 01/12/2018
Seem decent for the money, they also use silicone wire which is much better than the cheaper ones I have seen.
Li-Po Batteria Equilibrio Carica Estensione Cavo 20cm 2S 3S 4S 6S
US$5.74 US$5.99
0
raccomandazioni
Commento (0)
Darren 01/12/2018
I wish they did larger packs of this, it's good stuff!
127Pz 2 Senza Alogeni: 2:1 Tubo Termoretraibile Guaina Involucro
US$9.23 US$12.99
0
raccomandazioni
Commento (0)
Darren 01/12/2018
The heat resistance of this tape is great.
Pellicola Poliimmide ad Alta Temperatura Nastro Resistente al Colore con 5 Modelli
US$4.61 US$4.99
0
raccomandazioni
Commento (0)
Darren 01/12/2018
Good for the money!
Cavo di Bilanciamento per LiPo JST-XH 2S 3S 4S 5S 6S per Caricabatterie di Alimentazione 10CM
US$11.54 US$11.99
0
raccomandazioni
Commento (0)
Darren 01/12/2018
I have purchased a few of these now and can honestly say they are quite good. Well done Banggood!
Modulo di bilanciamento delle celle della scheda di protezione della batteria al litio 18650 Li-ion 14S 45A 52V
US$26.55 US$27.99
0
raccomandazioni
Commento (0)
Darren 01/12/2018
I had lots of problems with this, it seems much more inaccurate than a regular ruler and the solar part of it is useless under led light (which is not a surprise).
150 millimetri lcd strumento di misura composito in fibra di carbonio calibro digitale solare
US$19.62 US$20.99
0
raccomandazioni
Commento (1)
Kit stampante 3D in alluminio TRONXY® X5ST-400 fai-da-te 400 * 400 * 400mm di grandi dimensioni
US$389.99 US$505.99

D: I have the Tronxy XY-08N level sensor for the X5ST, how do I enable it?

Domandata da Darren il 2018-11-30 01:23:18

Waddleeeenn if it is plug and play type, can use directly

2018-12-04 09:34:44 Utile (0)
Consegnare
risposta (1)
Darren 28/11/2018
This printer is awful. It came with absolutely no instructions what so ever and the bed is totally warped which makes it useless. If you use glass over the top you will have uneven heating and possibly bend or break the glass. The extruder motor is also faulty. The printer was also supplied with some 3d printed parts which I would not expect from a printer kit of this value. The only good thing about is all the revised parts from all of the other versions of it like the X5S etc.
Kit stampante 3D in alluminio TRONXY® X5ST-400 fai-da-te 400 * 400 * 400mm di grandi dimensioni
US$389.99 US$505.99
3
raccomandazioni
Commento (1)
Kit stampante 3D in alluminio TRONXY® X5ST-400 fai-da-te 400 * 400 * 400mm di grandi dimensioni
US$389.99 US$505.99

D: I have the sensor to upgrade my X5ST 400 but how do I turn on the firmware support?

Domandata da Darren il 2018-11-23 12:21:51

Lovable what sensor

2018-11-27 03:13:58 Utile (0)
Consegnare
risposta (1)
Darren 30/10/2018
Good stuff. I have not tested it's resistance to heat or flames but it seems just like all the other insulation tapes I have used. It also has a nice pattern embossed into it which makes it look a bit more expensive than regular insulation tapes (which it is).
Nastro isolante elettrico da 10 m Nastro adesivo elettrico per uso domestico
US$2.99 US$4.99
0
raccomandazioni
Commento (0)
Darren 30/10/2018
This alarm is quite good quality and functions well. The range of the remote is very good, the LED is quite bright and the battery life is good.
ANTUSI 3 in 1 Luce posteriore wireless per bicicletta Telecomando ciclismo Allarme di blocco Lucchetto per bicicletta da mountain bike
US$28.86 US$38.00
0
raccomandazioni
Commento (0)
Darren 30/10/2018
I have purchased quite a few of these and they have always been of reasonable quality. The price has increased over the last few months though.
Porta batteria fai da te per 10 pezzi con 4 slot per batterie 18650 e 8 connettori
US$22.99 US$26.99
0
raccomandazioni
Commento (0)
Darren 30/10/2018
These will not accept a heavy AWG wire. They perform OK and are pretty sturdy but if you want to use them at high current due to their "copper" material then you should probably look for something else as they simply will not accept more than 12AWG.
DANIU P3008 10Pz 4mm Spina a Banana di Rame Sonde di Prova per Amplificatore per Altoparlanti Connettore Presa
US$13.85 US$14.99
0
raccomandazioni
Commento (0)
Darren 30/10/2018
Very nice fitting covers!
Copertura protettiva in plastica per connettore XT60 Spark Plug in 3 pezzi per drone da corsa RC multirotor FPV
US$6.29 US$8.99
0
raccomandazioni
Commento (0)
Darren 30/10/2018
Very nice stuff, it's reasonably priced and performs very well under extremely high temperatures.
Pellicola Poliimmide ad Alta Temperatura Nastro Resistente al Colore con 5 Modelli
US$4.61 US$4.99
0
raccomandazioni
Commento (0)
Darren 30/10/2018
The quality of these vary massively. I have had 2 batches of these and there is a huge difference in quality. The first batch was really good quality and fitted very nicely but the second batch was really bad. It's the chance you take I guess when buying from China.
20 Coppie di Spina Banana Amass 4.0mm AM-1003E Maschio e Femmina
US$28.86 US$29.99
0
raccomandazioni
Commento (0)
Darren 30/10/2018
This stuff is quite good, I have not done any resistance tests but there is a noticeable quality difference when comparing this against another 8AWG silicone wire. I can't totally recommend this wire without doing a resistance test but I will say that going by the quality it will most likely be good stuff.
1M 8/10/12/14/16/18/20/22/24/26 AWG Cavo in silicone SR Wire
US$4.95 US$6.99
0
raccomandazioni
Commento (0)
Darren 30/10/2018
These are a very very tight fit, I had to warm mine up to make them fit but after that they fitted perfectly.
Coperchio protettivo AMASS XT60 XT90-S Anti-spark TPU per stampa 3D per cavi di modelli RC (2 pezzi)
US$6.92 US$7.99
0
raccomandazioni
Commento (0)

Sei l'esperto, puoi aiutare?

Ti invitiamo sinceramente a iscriverti all'e-mail di risposta all'invito!

Se ti iscrivi, ti inviteremo via e-mail a rispondere alle domande che le persone hanno sui prodotti. Iscrivendoti] guadagnerai anche il "Badge utile "! Puoi annullare l'iscrizione in qualsiasi momento nella pagina delle impostazioni sulla privacy.

Aiuta gli altri e sii più felice!

  • sottoscrivi

Informazioni sui badge

I badge sono collegati alla community e gli utenti guadagnano badge creando contenuti di qualità, completando missioni o partecipando ad attività speciali. Le persone specifiche avranno anche il proprio badge esclusivo.
Badge CEO

il badge ceo è di proprietà solo del boss di banggood.

I badge che puoi guadagnare arriveranno presto
  • OK

About Badges

Badges are related to the community, and users earn badges by creating quality content, completing missions, or by participating in special activities.

Helpful Badges

The Badge is awarded to users who are subscribed to the Invite Answer email and signifies their gratitude to help others. The badge appearance upgrades as the user helps more people.
  • OK

Thank you for subscribing! You have also earned a badge!

  • View It

Thank you! Your answer will help ###name### and ###num### other people!

Check awaiting answers to see more people who need help.

  • OK

Thank you! Your answer will help ###name### and ###num### other people!

Subscribe to "Invite Answer"emails and help others with product questions will earn you "Helpful Badge"!

  • Subscribe

Are you ready to help?

We invite you to subscribe to our Invite Answer email!

Subscribe and you’ll be invited to answer product’s question by email, which will also earn you a "Helpful Badge"! You can cancel any time on the privacy settings page.

  • Subscribe