packocrayons
i miei contenuti
Tutti i messaggi
Recensioni
Commenti
risposta
Domande

Tutti i messaggi

LUX 32-bit Processor Flight Controller Support PPM or Serial RX For Multirotor Racing
US$14.99

D: What target are these flashed with? I'm having an issue with

Domandata da boaterguy il 2017-11-10 08:53:42

BG351738321 4. Supports PPM or Serial RX (including Futaba, FrSky, S.BUS). A signal inverter is already included Bye, Felicia

2022-02-08 01:08:40 Utile (0)
Consegnare
risposta (2)
packocrayons 23/03/2021
Really weird servos. Not a full metal gear train, only the output gear is metal (not the gear that fails). The build quality is all over the place, with the rotation stop being a hardened steel pin (expensive), but having a plastic gear train. I bought these with the intent of modifying for continuous rotation, and I succeeded, but the design of the potentiometer as the output shaft locator makes it quite difficult to do so.
4PCS Racerstar MG90S 9g Micro Metallo Ingranaggio Servo Analogico Per Elicottero RC 450 Auto RC Barca Robot
US$18.47 US$19.99
1
raccomandazioni
Commento (1)
packocrayons 23/03/2021
Awesome little micro cam for a tiny trak build. Awesome that it can handle anything from 1S to 4S
Caddx Ant 1.8mm 1200TVL 16:9/4:3 WDR Globale con OSD Telecamera FPV Nano Ultra Leggera da 2g per Drone da Corsa FPV
US$21.90 US$26.39
0
raccomandazioni
Commento (0)
packocrayons 23/03/2021
This has become my daily driver iron/station. It's reliable, heats up quickly, and has a wide range of temperatures. Comes with some heavy tips and with the heat cranked, this can get through ground planes on PDBs/ESCs pretty reliably. Hot air gun is great, however the tips/barrels are a little finnicky. I don't like that the firmware runs a cooldown loop because it dumps hot air and you have to be careful where your station is placed (not near a wall).
Stazione di saldatura e pistola ad aria calda Drillpro 2 in 1 da 750W 220V / 110V Riscaldatore Display LCD Saldatore a temperatura controllata Stazione di riparazione per cellulare BGA SMD PCB IC
US$56.99 US$69.99
0
raccomandazioni
Commento (0)
packocrayons 23/03/2021
Have become my go-to vtx. Power output is not as rated, and I don't like that it can't support 6S (though some say they have had success). The older version had a straight MMCX to SMA connector, and newer ones have a 90-degree MMCX to RP-SMA. I appreciate the 90 degree bit, but the switch to RP-SMA is frustrating.
Trasmettitore FPV Eachine TX805 5.8G 40CH 25/200/600/800mW con display a LED TX, supporto OSD/Pitmode/Smart Audio
US$28.99 US$45.99
0
raccomandazioni
Commento (1)
packocrayons 23/03/2021
Sweet little boosters, using them for 1S lipo stuff so I can run 5V devices on them. I'd like to put an oscilloscope on the output to see how noisy they are, but I usually throw on a capacitor anyways.
Convertitore di tensione DC-DC Step Up Boost da 6W 3V 3.3V 4.2V 4.5V a 3.7V 5V 12V per modulo batteria al litio 18650 403040 Li-Po Li-ion
US$4.49 US$6.28
0
raccomandazioni
Commento (0)
packocrayons 23/03/2021
As usual, the adhesive on these leaves a lot to be desired. However, they're LEDs and they work. No dead segments yet.
5M 24W DC12V 300 SMD 2835 Striscia flessibile LED impermeabile Bianco/Caldo/Bianco/Blu/Rosso/Verde/RGB
US$11.54 US$11.99
0
raccomandazioni
Commento (0)
boaterguy 15/08/2019
These little things have outstanding audio quality for the price. I would love to see more information on the chip used, it definitely looks like there's a serial port that could be hacked into to change some of the settings, but it's hard to tell whether they're manufactured in (write-once registers) or if things like the name, the audio recording on boot etc can be modified. The numbers on my chip don't match that of the photo, and none of them really turn up much, so I'll have to try out sending it an "AT" and see what happens
Bluetooth 4.0 Audio ricevitore Modulo per amplificatore per altoparlanti audio stereo a doppio canale JDY-62A Supporto IOS
US$4.99 US$14.00
1
raccomandazioni
Commento (0)
packocrayons 15/10/2019
A 30mm stack puts two of the standoffs through arm mounts. I'm not a fan of this as crashes can damage the stack, and vibrations may transmit more. It's a very light frame, and despite other reviews, I believe the arms are stiff enough for use. I like the antenna mount that's included, takes the load off of the vtx. Cut quality could use some improvement as holes are not all perfect fit and there are some weird edges. Mounting a large, long range battery may be tough, but I don't believe that's the intent of this frame
Sloss'7 7 Pollici 270mm interasse 4mm spessore telaio in fibra di carbonio Kit telaio per RC Drone FPV Racing
US$25.22 US$30.26
2
raccomandazioni
Commento (0)
packocrayons 15/10/2019
A 30mm stack puts two of the standoffs through arm mounts. I'm not a fan of this as crashes can damage the stack, and vibrations may transmit more. It's a very light frame, and despite other reviews, I believe the arms are stiff enough for use. I like the antenna mount that's included, takes the load off of the vtx. Cut quality could use some improvement as holes are not all perfect fit and there are some weird edges. Makes a great ultralight build (1507 3600kv and 850mah 4S)
Sloss'5 Telaio in Fibra di Carbonio con Spessore del Braccio di 4mm e Passo Ruota di 205mm Kit per Drone RC FPV Racing
US$25.40 US$26.99
1
raccomandazioni
Commento (0)
boaterguy 17/04/2019
Works on dsmx with 2048, intuitive, easy to use, doesn't blow up on 5v, bind light is visible. No idea on longevity Antenna seems a little long for 2.4GHz, but that leaves a section to route out of a canopy (not how antennas work though).
Compatibile solo con DSG2 DSM2 Pro FPV ricevitore da 0.8g 2.4G per trasmettitore JR SPECTRUM RC Drone
US$11.36 US$11.99
1
raccomandazioni
Commento (0)
packocrayons 24/01/2020
Good, cheap source for custom kalimbas or as a replacement. Numbering scheme is a little weird until you figure it out. Looks like mahogany wood parts. Very low grade (I replaced these). Otherwise the parts are good quality, especially for the price.
17 tasti DIY kalimba pianoforte a pollice parti per la percussione
US$12.69 US$13.99
0
raccomandazioni
Commento (0)
packocrayons 06/12/2019
Neat little straps. Awfully slippery but they are the lower end ones so that's expected. Metal D ring is nice.
Cinghia di fissaggio in lega di alluminio RJX HOBBY, nera, per drone da corsa FPV
US$9.23 US$9.99
0
raccomandazioni
Commento (0)
packocrayons 06/12/2019
Love these receivers. The connectors are nice but I wouldn't be against a direct solder version as well for quads that don't need all those connections. Range is great. They are very expensive receivers but that's the price to pay for long range.
Frsky R9 Slim + 6 / 16CH Telemetry RC Mini ricevitore Ottimizzato 900MHz a lungo raggio con 2 antenne rimovibili
US$28.77 US$36.45
0
raccomandazioni
Commento (0)
packocrayons 06/12/2019
Replacing an XM. Appreciate the diversity and definitely helped in some areas the XM struggled before. A bit pricey, but I would argue worth it.
FrSky XM Plus Micro D16 SBUS Ricevitore RC Mini a Lungo Raggio Fino a 16CH per Drone da Corsa RC FPV
US$24.14 US$29.99
0
raccomandazioni
Commento (0)
boaterguy 27/09/2019
Not a bad flight controller for the price. I prefer the matek style rubber standoffs to the m4 gummies, but they seem to work alright. ICM20608 picks up more vibration than an MPU6000 or similar, but that's to be expected
JHEMCU 30.5x30.5mm Dual Gyro F7 Controller di volo AIO OSD 5V 8V BEC e nero Scatola per RC Drone FPV Racing
US$32.99 US$39.99
0
raccomandazioni
Commento (0)
packocrayons 15/10/2019
Love these props. Great slow cruisers but they can start to flatten out with enough power through them. That's rarely a practical issue and more of a "how fast can I hit the straosphere" issue.
2 coppie HQProp DP7X3.5X3V1S Durable 7035 7x3.5 7 Pollici Elica a 3 pale per RC Drone FPV Corsa
US$9.23 US$9.99
0
raccomandazioni
Commento (0)
boaterguy 29/05/2019
The landing pads are a little strange, but I just didn't stick them on. Nice frame and has some good features. The edges on the carbon need breaking, they have some flashing/burr from the cutter. Not sure how I feel about the arm bolts going directly into the stack, I would prefer metal bolts or something, in a hard enough crash the impact may transfer load into the stack which is not desirable.
Uranus'7 295mm Passo 7 Pollici Kit telaio in fibra di carbonio Braccio 4mm per RC Drone FPV Racing
US$39.26 US$40.99
0
raccomandazioni
Commento (0)
boaterguy 13/05/2019
Data lines are just shorted, so it's basically useless for most modern phones. Fortunately LG phones don't need stupidly complex charging circuits, so this works great for them.
Modulo di alimentazione Step Down DC-DC 9V/12V/24V/28V a 5V 3A Caricabatterie per cellulare USB regolatore Buck
US$7.34 US$10.99
0
raccomandazioni
Commento (0)
3pcs 6W 3V 3.3V 4.2V 4.5V a 3.7V 5V 12V DC-DC aumentare Convertitore boost per 18650 403040 Li-Po Li-ion Modulo Batteria
US$5.39

D: How do I select which voltage I want to purchase? (3.7/5/9/12 version)

Domandata da packocrayons il 2019-10-24 01:17:50

Invi Now you can select the voltage

2019-10-30 09:21:46 Utile (0)
Consegnare
risposta (1)

Sei l'esperto, puoi aiutare?

Ti invitiamo sinceramente a iscriverti all'e-mail di risposta all'invito!

Se ti iscrivi, ti inviteremo via e-mail a rispondere alle domande che le persone hanno sui prodotti. Iscrivendoti] guadagnerai anche il "Badge utile "! Puoi annullare l'iscrizione in qualsiasi momento nella pagina delle impostazioni sulla privacy.

Aiuta gli altri e sii più felice!

  • sottoscrivi

Informazioni sui badge

I badge sono collegati alla community e gli utenti guadagnano badge creando contenuti di qualità, completando missioni o partecipando ad attività speciali. Le persone specifiche avranno anche il proprio badge esclusivo.
Badge CEO

il badge ceo è di proprietà solo del boss di banggood.

I badge che puoi guadagnare arriveranno presto
  • OK

About Badges

Badges are related to the community, and users earn badges by creating quality content, completing missions, or by participating in special activities.

Helpful Badges

The Badge is awarded to users who are subscribed to the Invite Answer email and signifies their gratitude to help others. The badge appearance upgrades as the user helps more people.
  • OK

Thank you for subscribing! You have also earned a badge!

  • View It

Thank you! Your answer will help ###name### and ###num### other people!

Check awaiting answers to see more people who need help.

  • OK

Thank you! Your answer will help ###name### and ###num### other people!

Subscribe to "Invite Answer"emails and help others with product questions will earn you "Helpful Badge"!

  • Subscribe

Are you ready to help?

We invite you to subscribe to our Invite Answer email!

Subscribe and you’ll be invited to answer product’s question by email, which will also earn you a "Helpful Badge"! You can cancel any time on the privacy settings page.

  • Subscribe