Tutti i messaggi

BG174585419 This answer is incorrect. An Amateur Radio license is required to use certain frequencies or bands set aside for license holders and the FM radio band is NOT one of the bands. Per the FCC website: "Unlicensed operation on the AM and FM radio broadcast bands is permitted for some extremely low powered devices covered under Part 15 of the FCC's rules. On FM frequencies, these devices are limited to an effective service range of approximately 200 feet (61 meters)" That equates to very low power! Most likely about one tenth of a watt or less! If you break these rules it is a $10,000 fine!

2023-04-25 12:16:20 Utile (1)
Consegnare
risposta (2)

wdebelg You will only get high or low pulses. These should be counted. I use an Arduino with interrupt routine. (every time the flowmeter creates a pulse, a software counter is activated) If you have no knowledge about Arduino (or any other microcontroler), I don't think this is something you can use.

2020-09-02 02:10:21 Utile (0)
Consegnare
risposta (1)

Rui Press a few seconds until the number starts to flash, then use the up or down arrow button. Use the same method for the minimum and maximum temperature of each probe. Out lights up when the temperature recorded by the probe is far beyond the set point, but I'm not sure.

2020-02-01 07:07:06 Utile (1)
Consegnare
risposta (2)

D: Will this work in fuel tank ? Gas and diesel ?

Domandata da buzzy il 2019-07-12 09:12:26

ve7dvb Itisn't intrinsically safe so not advised to use with combustible fluids.

2019-12-31 02:15:07 Utile (0)
Consegnare
risposta (1)

CrazyCrow Works with any float unit that has a 2 wire connection.

2019-08-30 03:59:44 Utile (0)
Consegnare
risposta (1)

Talismanwas This is a non-direct output, vcc is the working positive, GND is the working negative, K0 and K1 are the control terminals, also need to be connected to the power supply, the relay is disconnected without power

2019-06-28 03:05:25 Utile (0)
Consegnare
risposta (1)

D: What is the Current draw at 6 volts ?

Domandata da buzzy il 2018-08-15 02:20:41

Thrilled Voltage Range: 4.8V-7.4V RPM: 22000-46000

2018-08-16 06:15:51 Utile (0)
Consegnare
risposta (1)

D: What is the Output RPM ? That is, the RPM of the output shaft ?

Domandata da buzzy il 2018-08-15 02:16:43

Mrmartinc Voltage Range: 4.8V-7.4V RPM: 22000-46000

2018-08-16 06:15:22 Utile (0)
Consegnare
risposta (1)