Andrew1978
D: I wonder what prevented to make the size 15х24х8? Real size 15.86 x 25.8 x 8.1 mm
Domandata da Andrew1978 il 2018-10-24 07:29:27
Jerry Fit for 8mm shaft
2018-11-04 09:51:45 Utile (0)
D: Planet CNC? What about soft?
Domandata da Andrew1978 il 2018-03-22 12:51:39
BogumMatt Sorry I don't understand what do you mean.
2018-03-26 09:28:26 Utile (0)
Andrew1978 how many lumens per strip?????????
2017-11-23 02:37:51 Utile (0)Ti invitiamo sinceramente a iscriverti all'e-mail di risposta all'invito!
Se ti iscrivi, ti inviteremo via e-mail a rispondere alle domande che le persone hanno sui prodotti. Iscrivendoti] guadagnerai anche il "Badge utile "! Puoi annullare l'iscrizione in qualsiasi momento nella pagina delle impostazioni sulla privacy.
Aiuta gli altri e sii più felice!
Thank you for subscribing! You have also earned a badge!
Thank you! Your answer will help ###name### and ###num### other people!
Check awaiting answers to see more people who need help.
Thank you! Your answer will help ###name### and ###num### other people!
Subscribe to "Invite Answer"emails and help others with product questions will earn you "Helpful Badge"!
We invite you to subscribe to our Invite Answer email!
Subscribe and you’ll be invited to answer product’s question by email, which will also earn you a "Helpful Badge"! You can cancel any time on the privacy settings page.
Kworsfold From what I am reading (yet to be proven) but leaving these three microstep selection pins (MS1, MS2 and MS3) disconnected results in full-step mode pulling low (as per the track on the PCB) would result in Single step. As for Direction and Enable these are ACTIVE LOW.......... i.e. LOW to Enable and not reversed (reversed motor could be wiring or mechanical issues)
2019-03-20 10:51:00 Utile (0)