BG142017342 I'veused the charger for a couple of weeks now. It works fine with the fake-makita batteries i also bought from banggood. The charger has a fan inside. It is a little loud, like louder than a bad laptop. I wouldn't use the charger in a living room, but for a workshop, the fan noise would be ok, i guess. The charger playes music, when you plug in a bettery and when it is done charging. The lights also tell you when it is done charging. The fan noise also stops when it is done charging.

BG142017342 Ihave used the saw for about a month now and will give my review on the circular saw. There were no saw blade in my delivery, even though some other commenters mentioned they got a blade included. It uses a 20mm arbor and fits a blade of maximum 165mm. The protective cover does not use a spring, so you will have to manually cover the blade after making a cut. The guide is unusable. It only uses one bar, one screw through a hole that is too big. The depth stop is difficult to use. Even though there are markings for the depth, there is no indicator arrow, to tell you what depth of cut you have set. I havent used the angle function, but out of the box my cuts were at 90 degree. I have cut 45mm pinewood and 4 layers of 12mm pine plywood, without any major problems, but that appears to be the saws maximum capacity. The saw is fine for its price.

BG142017342 Ihave had some time to use the trim router a little now and it works well when you have good bits. The included wrenches are very bad. I had tighten the nut, but when i tried to un-ttighten it the small wrench deformed instead of turning. It is better to have a proper set of wrenches when changing the bits.

BG142017342 Ihave had the planer for about a month now. I have used it on 45mm pinewood and on the edges of 12mm pine plywood. The planer works fine. I have not taken deeper cuts than 1mm and the planer has not had any trouble handling any of the woods. The planer is powerfull. I have not regretted my purchase and would recommend this planer, to anyone looking for a cheap and good planer.

BG142017342 Ihave used the drill for about a month now. I have used it for drilling and screwing. The chuck is not centered on the axis of rotation. I suspect it is 0.3mm off center. It might not sound like a lot, but when i'm using a drill that is more tan 5cm in length and 5mm in diameter, it sends a lot of vibrations through the machine. The hole ends up being 0.6mm larger than the drill. The low/high switch is opposite on my drill, so when it is in L it is actually in the fast gear and when it is in H it is in the low gear. For the price i don't regret my purchase, but i had hoped for better quality. The drill is fine for small drill bits and screwing short screws. It feels powerfull enough, but i wouldn't recommend this machine.

BG142017342 Soi finally got around to using some of the bits. The flush trim bits bearing violently dissambled itself after only trimming a depth of around 1mm and a length of 30cm. Since flush trim bit uses a different size bearing than the rest, i am left with out a flush trim bit, because i can't swap it from one of the other bits.

BG142017342 Ihave used the 20mm bit and it is not as precise as i had hoped. The hole it makes is 20.4mm.