Neil van der Linden
- i miei contenuti
- Tutti i messaggi
- Recensioni
- Commenti
- risposta
- Domande
risposta
Neil van der Linden As in the description it comes with the VCD (speed controller). You will have a hard time running it from your 3018 VCD as this 500w spindle runs on 100v PWM and if memory serves, the 3018 runs on 40V.
Utile (0)
D: is it a brushed or brushless motor ??
Domandata da DONJHO il 2021-01-23 17:31:57
Neil van der Linden It is a brushed motor.
Utile (1)D: What is the REAL OUTPUT POWER of the power supply? (Voltage and Current)
Domandata da PC317 il 2020-11-28 01:47:02
Neil van der Linden Voltage 100V PWM. Current I am not so sure.
Utile (1)D: On the power supply, which one is positive?
Domandata da marcuus il 2020-11-04 20:21:03
Neil van der Linden The polarity of the 12V output side does not matter really. I put mine positive left and negative on the right hand side. I would suggest however that you ground the casing and move the VCD away from your electronics so as to avoid electrical noise.
Utile (1)
D: I need this cut to 235 mm size, can you do that?
Domandata da Ged il 2020-09-22 12:20:46
Neil van der Linden This is a very hard tool steel rail. You will need to have it professionally cut or very accurately with a cut off saw and de-burr it.
Utile (0)
Neil van der Linden You need to use a common earth to close the loop. Earth from your mains to the side of the controller unit. Also earth your machine. that should help.
Utile (0)
Neil van der Linden The fan blows down onto the motor.
Utile (0)