risposta

D: Hi! 6-pin connector on pcb, what is it for?

Domandata da krivov il 2017-12-09 03:48:58

SeanTheITGuy pwm1,2,4,3,5v,gnd. could be run to a 4in1 esc.

Utile (0)
Consegnare
risposta (3)

D: Can I use for aeroplanes?

Domandata da PRaj il 2021-08-17 03:59:41

SeanTheITGuy You would need a flight controller in your plane. The receivers have no PWM outputs, so you couldn't hook it directly to servos and ESCs. If you have a flight controller, then yes.

Utile (0)
Consegnare
risposta (1)

D: could you make that device work as a wifi range extender?

Domandata da angelnonis il 2020-10-12 05:17:58

SeanTheITGuy Yes, using the project esp_wifi_repeater (on github) you could use this as a wifi range extender. It's just an esp8266 board that's been customized for this one "testing" purpose, but you could use it for any 8266 project.

Utile (0)
Consegnare
risposta (2)

SeanTheITGuy The information is not correct. There is no button. This unit is configurable through smartaudio only, which makes it sort of a pain to use. It's meant to be a pre-assembled part with a tiny board camera, hence the tiny, poorly labelled solder pads.

Utile (0)
Consegnare
risposta (1)

D: Supported propellers ?

Domandata da nandudkar il 2019-03-17 11:12:57

SeanTheITGuy They have an M6 thread, the CW has a 8.5mm shaft, and the CCW has a 7mm shaft. They are a little odd for props, and I have taken to boring out the hub of old props I had on hand to fit. These motors are spares for the Xiaomi 4k camera drone, so any props meant for that should work.

Utile (0)
Consegnare
risposta (1)

SeanTheITGuy It's not super tidy of a soldering job, but yes, the capacitors are all tied in parallel as they are acting in two banks to be filtering caps. They could have used a single larger cap per side, but the form factor and size restrictions of the device limit that ability.

Utile (0)
Consegnare
risposta (1)

SeanTheITGuy I would never trust the BEC built into an flight controller. Use a PDB with purpose built BEC circuitry, and run your flight controller and IMU sensors from that. If you do that, VBAT is irrelevant.

Utile (1)
Consegnare
risposta (0)