Modulo adattatore USB Wi-Fi ESP-01S LINK V2.0 ESP8266 di OPEN-SMART con driver 2104
Una parte della recensione è stata tradotta automaticamente.
Arrivato sano e salvo. Le prime impressioni sono state tiepide come la scheda guardare malconcio, ma era solo flusso non lavato. C'è una maneggevole freccia ti aiutare a ottenere il ESP01s collegato nel modo giusto intorno, e fare attenzione è molto facile sbagliare. Per usarlo come programmatore per l'IDE Arduino, tutto quello che dovete fare è aggiungere un semplice switch tra IO0 e GND per farlo entrare in modalità flash. Semplice.
I plan to use this adapter for ESP 8266 - 01. It looks OK, but there are missing any instructions. I have found driver on internet, so the driver in my PC is OK. Adapter itself could be OK, there is 5V to 3.3V conversion, but I was not able to upload software to ESP 01 board. Missing switch GPIO0 to GND (for software upload). My ESP01 module was not S type, so maybe this was a problem.
....
While plug using 3 different item ESP8266 the unit overheat need to remove quick
For this Programmer the ESP-Module has to be placed outwards. For me the standard DTR/CTS control for programming is not working using Arduino IDE! First of all I had to solder a pullup resistor between VCC and the CD_PD pin. To put the ESP-01 in programming mode GPIO has to be pulled to ground (soldered a jumper to the pin) followed by pressing the Reset button. For Nral opreation the Jumper should be removed again.
Ottimo prodotto funziona correttamente
Arrivati in buone condizioni
Fa il lavoro
Utile per esp01s
BUONI VOCI