Recensioni clienti

4.94 su 5
Scrivi una recensione
  • Tutte le recensioni (72)
  • Immagine (4)
  • Video (0)
  • Tutte le stelle
    • Tutte le stelle(72)
    • 5 Inizia(68)
    • 4 Inizia(4)
    • 3 Inizia(0)
    • 2 Inizia(0)
    • 1 Inizia(0)
Ordina per:
Recensione Top
  • Recensione Top
  • Il più utile
  • Più Recente
Recensioni solo dal tuo paese (Italy)
  • 21/11/2016

    Despite the small difference in appearance, the device is as as described. Everything works normally. Only problem I had when supplied with 12.14 volts. Although LEDs lit, no output voltage. I suppose that the maximum supply voltage is a little less than 12 volts.

    Commento
  • 26/04/2018

    Used for Arduino projects - just search for "Arduino L9110S" on Google, and you will find Lib and examples. Even with a "short" on the motor side, I have not been able to "Kill" the board

    Commento
  • 26/05/2020

    il pacchetto DEVE essere migliorato. Alcuni perni sono plis

    Commento
  • 05/05/2018

    Pretty nice

    Commento
  • 05/07/2020

    Funziona alla grande, solo perche'l'imballaggio non era buono e i perni erano piegati.

    Commento
  • 03/04/2021

    buona

    Commento
  • 22/02/2021

    pienamente conforme e, naturalmente

    Commento
  • 26/03/2017

    Tested with a pro mini and worked great. I had to try two different power plug supply's, one was 12.3 volts even though it was labeled as 12 volts and it did not work. It did not damage it but be careful it might. 12 volts might be its absolute max. I will probably use this with a 9 volts just to be safe

    Commento
  • 07/03/2017

    Just be sure that you check the connections to match them with your circuit. (Vcc, GND, A1A, A1B,etc.) The connecting pins are in a different order than the ones on the controller shown in the diagrams in my project. Not a problem; the controller will work fine when you connect the wires correctly according to the labels printed on the board.

    Commento
  • 31/01/2016

    This little part has some punch when driving DC motors. I tested both drivers on my robot and they worked like a charm. But after measuring the current, it looks like the HD7881 chips do tend to heat up quite a bit when the load current exceeds ~350mA. Yes, the part is rated for 800mA, so it might make sense to add a small heat sink when dealing /w heavy loads. Otherwise, this is just perfect for small (i.e. light load) projects. I will definitely order more of these parts !

    Commento
Show:

    Totale 0 pagine

    Vai alla pagina

    Magari ti piace

    recommendation for you
    • 14,06€
    • 6,61€
    • 14,88€
    • 6,61€
    • 10,75€
    • 20,67€
    • 19,02€
    • 14,88€
    • 44,67€
    • 6,61€
    • 28,12€
    • 5,78€
    • 7,44€
    • 12,40€
    • 10,75€
    • 6,62€
    • 9,09€
    • 20,67€