Modulo Trasmettitore Laser KY-008 AVR PIC
Una parte della recensione è stata tradotta automaticamente.
but nothing too bad. what is marked with (-) should go to pwm pin as signal, middle pin should go to ground from external power source (MB102 is great for that!) and what is marked as (S) becomes + from external 5v power. once this is connected laser is nice and precise.
It's a great module but the laser itself is not really aligned with the board . It goes a little bit on the right ! That's the right way to connect it to your arduino : "S" : signal _connected to a digital pin "-" : Connected to the ground Middle pin : connected to 5 volt
buono, ma gnd e 5v sono misti
good quality It will be tested soon
Very small and cheap module for arduino.
This is very good priced item. I suggest buying it. Delivered fast and very useful.
questi funzionano alla grande e il gusto incredibile
Grande piccolo modulo, anche se la zona marcature off. Gnd ottiene 5v S per la fornitura 0v per una permanente sullo stato. Il meccanismo di messa a fuoco funziona abbastanza bene per un fascio largo, se necessario.
On Arduino UNO you can plug directly into GND 13 (put the middle pin in there) and use Pin 12 for the S pin.
Now all I need is the sharks on which to put this laser beam.