Sensore piacevole, facile da installare in Arduino.

Nice sensor, easy to setup in Arduino.

Sensore piacevole, facile da installare in Arduino.

Werde in meinem nächsten Projekt diesen Sensor benutzen. Lieferung verlieft ohne Probleme und nichts ist beschädigt.

Werde in meinem nächsten Projekt diesen Sensor benutzen. Lieferung verlieft ohne Probleme und nichts ist beschädigt.

Werde in meinem nächsten Projekt diesen Sensor benutzen. Lieferung verlieft ohne Probleme und nichts ist beschädigt.

Bene

Good

Bene

Funziona bene

Works good

Funziona bene

Misura della temperatura molto accurata.

Very accurate temperature measurement.

Misura della temperatura molto accurata.

It's humid in here, too sweaty to tell.

It's humid in here, too sweaty to tell.

It's humid in here, too sweaty to tell.

Very pleased with this, better accuracy than the more common ones, and easy to get going.

Very pleased with this, better accuracy than the more common ones, and easy to get going.

Very pleased with this, better accuracy than the more common ones, and easy to get going.

Arrived well packed and as described. Not tested yet

Arrived well packed and as described. Not tested yet

Arrived well packed and as described. Not tested yet

Great breakout board for a small chip, the optional 4 pin connector allows various connection options

Great breakout board for a small chip, the optional 4 pin connector allows various connection options

Great breakout board for a small chip, the optional 4 pin connector allows various connection options

these sensors work as expected. quite accurate and very sensitive. it does not have any built in pull up resistors so you will have to put it in if it is the only device on the i2c bus.

these sensors work as expected. quite accurate and very sensitive. it does not have any built in pull up resistors so you will have to put it in if it is the only device on the i2c bus.

these sensors work as expected. quite accurate and very sensitive. it does not have any built in pull up resistors so you will have to put it in if it is the only device on the i2c bus.