Tutti i messaggi

D: What is required to run 4S?

Domandata da Azzam il 2017-11-23 12:09:52

--oz-- As a minimum, 4S is highly recommended unless your a beginner pilot. After a friend has success with 6S, he is now going for 8S.Use a larger spar.

2020-11-29 09:08:49 Utile (0)
Consegnare
risposta (2)

D: how can i use this as an Arm button?

Domandata da Emmanuel il 2019-05-09 02:57:48

--oz-- There is a special function called "sticky", look it up on otx university.

2020-03-19 11:09:33 Utile (0)
Consegnare
risposta (2)

D: Is it possible to get it into Mode 1 ?

Domandata da mbaui il 2019-11-16 10:51:49

--oz-- Its mode 1 or 2, simply open it up, and adjust the screw to switch modes. Dont listen to the other guy.

2019-12-01 04:47:50 Utile (0)
Consegnare
risposta (3)

D: What can be programmed on this ESC and how is it done ?

Domandata da gbdc85 il 2019-09-14 05:58:14

--oz-- Since I cant post links here, search BLHeli_s manual, all the settings are adjustable by Tx (kinda a pain, but no more a pain than any other esc Tx programming), or use a $2 arduino nano or use a flight controller (betaflight/etc).

2019-09-14 05:29:06 Utile (1)
Consegnare
risposta (1)

boblocke AllI had to do was wrap the plastic cover around the receiver and use it as a conventional 6 channel receiver . I did not use the 16 channel S port.

2019-07-29 07:41:28 Utile (1)
Consegnare
risposta (1)

D: why doesnit need a driver

Domandata da louisvr45 il 2018-10-20 02:21:42

--oz-- LEDs need the current controlled, if you just use a power supply with variable voltage, the current changes a lot with very very little voltage change, also when the led heats up, the required voltage drops a little. This causes a problem because the current will rise. At least use a resistor or a current limited power supply

2019-02-07 01:45:48 Utile (1)
Consegnare
risposta (4)