Tutti i messaggi

D: What is the max RF Power for this bridge?

Domandata da BG172101915 il 2022-01-17 11:27:44

BG321646142 Documentation indicates 100 W

2022-02-01 05:21:01 Utile (1)
Consegnare
risposta (2)

D: Is this chip genuine FTDI or clone?

Domandata da BG172101915 il 2021-02-07 10:52:48

WolfxPac how do you differentiate between them? it's open-source hardware using same USB to TTL IC.

2021-09-17 12:19:16 Utile (0)
Consegnare
risposta (2)

D: What is the measurement frequency for this unit?

Domandata da BG172101915 il 2020-02-28 12:37:22

BG555247215 Thisdevice measures earth ground resistance, not the frequency

2020-11-05 01:14:14 Utile (0)
Consegnare
risposta (2)

D: What is the diameter of

Domandata da rbusque il 2018-03-28 07:10:50

PampaWak About8mm. Please permit me 1-3cm of tolerance because of manual measure.

2020-05-05 12:07:28 Utile (0)
Consegnare
risposta (1)

D: What is the diameter of ceramic insulator protecting the wires?

Domandata da rbusque il 2018-03-28 07:11:37

PampaWak Idon't know exactly, but it's about 8/10mm. Sorry for this delay, but I didn't know about this part of the website!

2019-10-18 04:55:37 Utile (0)
Consegnare
risposta (1)

D: What is the diameter of the ceramic tube?

Domandata da rbusque il 2018-03-28 07:14:18

Sandu max12.4mm, min 10.4 mm - is eliptic, not round

2019-09-17 09:25:32 Utile (0)
Consegnare
risposta (1)

D: nela pode por 2 filamento ao mesmo tempo ?

Domandata da ????????? il 2019-08-11 07:20:32

rbusque Natively,it can only handle one filament at a time. This being said, my impression is that these are highly modifiable.

2019-08-12 07:53:23 Utile (0)
Consegnare
risposta (4)

rbusque Minedid not have magnetic platform. When I researched the resume function for this, though possible, it was clear there would always be some artifact in the print...I opted to not enable it. Printing can be done directly from the micro SD. Extruder is nothing fancy. I ended up installing a bed sensor for levelling...made a huge difference in repeatability.

2019-08-12 07:50:56 Utile (0)
Consegnare
risposta (4)