jdill
D: is the Power supply Standard select to 220V or 110 Volt ?
Domandata da b.stadler il 2019-10-10 02:32:12
jdill There is a switch inside the case that is used to select 110v or 220v. Mine had a sticker on the side of the case to warn of it.
2020-01-17 04:02:21 Utile (1)
jdill The 3 output terminals for V- and for V+ seem to use a common feed, so using just two terminals should be OK.
2020-01-17 03:55:15 Utile (0)
D: wich prop Is better for 4s?
Domandata da barrosjuaneduar il 2019-04-05 07:59:36
jdill I'm using it with a 12x6 propeller and it draws 36.8 amps and 495 watts at full throttle. The amperage of the motor isn't listed in the specifications but since they show 35 amps in the "Testing Data" it may be a 40 amp motor. So 37 amps should be no problem, especially for short periods.
2019-05-11 05:35:42 Utile (1)
jdill Try this: download and run the ImpulseRC Driver Fixer. It puts the flight controller into BOOT mode. Then run Cleanflight and use the Firmware Flasher to update the quad. Worked great for me on a QX90.
Ti invitiamo sinceramente a iscriverti all'e-mail di risposta all'invito!
Se ti iscrivi, ti inviteremo via e-mail a rispondere alle domande che le persone hanno sui prodotti. Iscrivendoti] guadagnerai anche il "Badge utile "! Puoi annullare l'iscrizione in qualsiasi momento nella pagina delle impostazioni sulla privacy.
Aiuta gli altri e sii più felice!
Thank you for subscribing! You have also earned a badge!
Thank you! Your answer will help ###name### and ###num### other people!
Check awaiting answers to see more people who need help.
Thank you! Your answer will help ###name### and ###num### other people!
Subscribe to "Invite Answer"emails and help others with product questions will earn you "Helpful Badge"!
We invite you to subscribe to our Invite Answer email!
Subscribe and you’ll be invited to answer product’s question by email, which will also earn you a "Helpful Badge"! You can cancel any time on the privacy settings page.
