BG435736750 No it does not. But you can wire one in if you buy it

BG435736750 Think you made a typo, if you meant the FlySky PL18 Paladin, then yes it's supported.

BG435736750 RHCP, It's an iFlight Albatross antenna

BG435736750 M5 nut with 8mm wrench

BG435736750 Both Frsky and FlySky will bind to Radiomaster. Suggestion is to get Frsky, works with more transmitters if you should change later.

BG435736750 The FrSky XM+ or Frsky R-RXSR will work with TX16S

BG435736750 The only difference between the 4s and 6s version is the motor kv rating. 5s might be too weak (but will work) for the 6s version, you can also apply a throttle limit to 4s version to protect it from going too high.

BG435736750 Yes, TX12 will work with xm+ or r-xsr receivers.

BG435736750 The TX12 has a Jr module bay that supports Crossfire, so should work for this as well.

BG435736750 XM+ will work fine for you. Range should be 1km+ with line of sight. Many videos out there show much further range as well, but I haven't gone out further (no space). You can also get R-XSR if you want telemetry sent back to the reveiver, but it's more expensive and you probably won't use it anyway.

BG435736750 Yes,binds with Frsky R-XSR or XM . XM does not have telemetry and is cheaper, recommended for freestyle.

BG435736750 Almost any 5 or 5.1 inch prop can be used. The originals are quite punchy, so if you would like the same, go for something with a higher pitch e.g. 5045 or 5050. Otherwise try some freestyle props, PB&J or Watermelon from HQ Prop (Mr Steele)

BG435736750 I did this on mine. Connect normal S.Port wire from receiver (not the un-inversion hack) to TX-2 on FC. Easiest way is to remove and relocate wire from RX2 to TX-2 on the FC plug connector. Follow Oscar Liang .com setup-frsky-fport for the rest of the setup.

BG435736750 It's SMA. Antenna has the sheath (outside) nut and middle prong.