Tutti i messaggi

D: what is the diameter of the hole required for this device?

Domandata da Coetz il 2017-12-16 08:18:04

Maminbot 46 mm or 1.8 inch exactly. So you will need a slightly larger bore with some gap as leeway. However bear in mind that the barrel does not come with a tensioning mechanism so you may need to pack it with some foam, otherwise it may rattle about. The surface cap diameter overhang is 67.8 mm or 2.67 inch.

2018-01-17 07:34:52 Utile (1)
Consegnare
risposta (1)

D: Where is the power supply?

Domandata da Glauve il 2017-12-26 12:14:40

Maminbot The 3 USB sockets are directly attached to a circuit board with a switch mode power supply. It's all contained in the tube below the surface.

2018-01-17 07:21:14 Utile (0)
Consegnare
risposta (1)