Commenti

mmihelic Afterthe second front left dogbone snapped at wheel hub I decided to install these. Unfortunately the pin hole on the wheel hub side is 5mm in diameter and the pin is 5,2mm. These do not fit! Good luck milling out steel with average household power tools.

mmihelic 22/03/2021
2
Commento (2)

mmihelic Running the crawler in-house the driveshafts came apart three times. Always the pin holding the articulating joint came loose. Luckily this happened inside, so I could find the little pin. After the incident I also checked the other three pins. They were all barely hanging in there. Imagine this happening on the trail in the woods, You'd never find the pin.I am very disappointed with this driveshaft.

mmihelic 12/01/2021
0
Commento (1)