LOLIN32 V1.0.0 Modulo WiFi + bluetooth ESP-32 4MB FLASH Scheda di sviluppo
Una parte della recensione è stata tradotta automaticamente.
Great board with excellent build quality. Connectors aren't soldered when it arrives but they are included so it is a trivial 2 minute job. The battery connector is of type JST PH 2.0mm so be careful when ordering small lipos that they have the correct type.
Maybe, Vbat may be added as output pin, in order to monitor the voltage with the ESP32...
A fantastic board-- supports Arduino with minimal hassle (all well documented). Small notes; using the Bluetooth stack requires re-partitioning the device (due to the stack needing 700KB+ and the default flash partition of 1MB) for which documentation exists too. The battery connector's polarity is backwards compared to all the TinyWhoop PH2.0 batteries I have- trivial to swap pins but be sure to check it!! All-in-all a device which packs an enormous amount of features for a super low price.
I put Micropython in it for testing. It works well since then.
Shopping veloce.
consegna un po 'di ritardo, parti consegnate o.k. vedrà funct... buoni puntelli per i miei progetti di casa
Worked perfectly once connected to the PC. I already had had installed Silicon Labs USB to COM driver, and after initial driver setup the board started to send data to the PC (picture #1), with COM port settings as shown in picture #2.
Nice esp32 dev board, if you take a look at wemos wiki, you will see that this model is discontinued, the latest boards are D32(Pro) : https://wiki.wemos.cc/start
ci è voluto così tanto per arrivare ma il suo funzionamento
Items as described