Recensioni clienti

4.89 su 5
Scrivi una recensione
  • Tutte le recensioni (18)
  • Immagine (2)
  • Video (0)
  • Tutte le stelle
    • Tutte le stelle(18)
    • 5 Inizia(16)
    • 4 Inizia(2)
    • 3 Inizia(0)
    • 2 Inizia(0)
    • 1 Inizia(0)
Ordina per:
Recensione Top
  • Recensione Top
  • Il più utile
  • Più Recente
  • 2020-01-24 09:15:30

    Arrived safe and sound. First impressions were luke warm as the board look tatty, but it was just unwashed flux. There is a handy arrow ti assist you in getting the ESP01s plugged in the right way around, and be careful it is very easy to get wrong. To use it as a programer for the Arduino IDE, all you need to do is add a simple switch between IO0 and GND to get it in to flash mode. Simple.

    Commento
  • 2018-09-11 16:16:25

    For this Programmer the ESP-Module has to be placed outwards. For me the standard DTR/CTS control for programming is not working using Arduino IDE! First of all I had to solder a pullup resistor between VCC and the CD_PD pin. To put the ESP-01 in programming mode GPIO has to be pulled to ground (soldered a jumper to the pin) followed by pressing the Reset button. For Nral opreation the Jumper should be removed again.

    Commento (3)
  • 2020-07-01 12:49:35

    arrived in good conditions

    Commento
  • Adri
    BE
    2020-06-19 10:44:54

    Fait le job

    Commento
  • flyfons
    IT
    2020-04-17 10:36:18

    Utile per esp01s

    Commento
  • 2020-04-03 10:00:15

    GOOD ITEMS

    Commento
  • Daniele
    IT
    2020-01-13 14:19:13

    ok

    Commento
  • mosheb3
    IL
    2019-12-03 02:21:53

    Good product

    Commento
  • Jesper
    DK
    2019-11-07 14:11:35

    All good

    Commento
  • Kamil
    SK
    2018-04-25 13:49:32

    I plan to use this adapter for ESP 8266 - 01. It looks OK, but there are missing any instructions. I have found driver on internet, so the driver in my PC is OK. Adapter itself could be OK, there is 5V to 3.3V conversion, but I was not able to upload software to ESP 01 board. Missing switch GPIO0 to GND (for software upload). My ESP01 module was not S type, so maybe this was a problem.

    Commento (2)
Show:

    Go to page

    Go

    Magari ti piace

    recommendation for you
    • 2,54€
    • 8,96€
    • 6,91€
    • 12,10€
    • 12,47€
    • 10,17€
    • 9,41€
    • 2,54€
    • 6,78€
    • 19,25€
    • 6,84€
    • 1,69€
    • 2,54€
    • 2,54€
    • 19,30€
    • 5,93€
    • 3,39€
    • 6,05€