MightyMon HiPolizyste. trying to get SBUS working. What do you mean by UART2 on RC-pin. Isn't UART2 in Betaflight the RX2 pin? And isn't RC-pin UART1?
Risposta 09/06/2019Polizyste I didn't change anything from the stock settings. Just soldered to RC-pin and changed to Sbus iin configuration. Serialrx was activated on UART2 in betaflight. Rx2 didn't work for me.
Risposta 15/06/2019georgelagardo DearPolizyste, please tell me if the arrow printed on the flight controller is actually points to front, because my flight controller is showing wrong orientation when i point the arrow towards front . and i need to add 270 deg in yaw to correct it.
Risposta 03/07/2019Polizyste I didn't really care about the orientation. I oriented for ideal wiring (short wires) and changed the orientation like you. After remapping the Motor signals in CL in Betaflight everything was fine. I think the orientation wasn't preprogrammed right from factory!d
Risposta 14/07/2019BG484844112 what firmware do u use?
Risposta 31/07/2019Polizyste I'm still doing very fine on latest stable release of BF v3. Didn't try v4 yet. Target should be hakrc f411 like said in the description.
Risposta 03/08/2019ChristianHilario Hey Polizyste, what frame are you using? I installed this in a FullSpeed Toothpick frame with 1103 7800kv and HQprop 65mm. It flies fine for about 30 seconds then falls to the ground. Motor keeps running "fine" but won't lift off.
Risposta 20/09/2019Polizyste I also noticed this problem using 2S on 1304 Motor loaded with 3" props at 96g AUW. If possible you should Upgrade to 2S lipo (lower amp Draw). I only noticed this issue while hovering, no Problems when flying acro, so I think it's an overheating protection.
Risposta 05/12/2019Polizyste I also noticed that the amp with all the new functions of BF v4 activated is much Higher than Stock setting in BF v3!
Risposta 05/12/2019La Nostra Azienda | Contattaci | Pagamento & Spedizione | Programmi di Partnership |
---|---|---|---|