Una parte della recensione è stata tradotta automaticamente.
I used this module to build a variable power supply. I use an input voltage of 12 volts (from a computer power supply) and need this module to create a variable (settable via the potmeter) output voltage ca 1 - 30 volt. With output voltages over 12 volts everything works fine. In the step down mode (voltages below 12 volt) the output voltage is not stable. For instance if I set the output voltage to 5 volts and apply no or very little load, then the outputvoltage "swings" between 4.8 and 5.3 volt. This only stops if I apply a larger load that draws at least 500mA of current.
L'ho usato per costruire un alimentatore da banco con 2 canali variabili e funziona bene.
Ordina in tempo e ben confezionato. L'ho testato con la mia fonte da banco e ho messo un multimetro sull'uscita e l'ho impostato per una presa a bassa tensione. Ma vi consiglio la massima attenzione a non invertire le tensioni di ingresso perché può dare luogo a problemi. Molto piccolo e molto compatto. Vi consiglio questo articolo.
Prodotto è stato imballato correttamente. Regolamentazione della linea è buona, testato con 5-30v in ingresso, e 2A carico. Adatto per led, o nessun dispositivo analogico senza filtro. Sono un po'deluso dalla scelta dei condensatori: sono a 105 gradi, ma solo a 35V. Quelli da 50v avrebbero permesso una vita migliore.
This is excellent step-up/step-down converter, that can be used for simple bench power supply. Replace variable resistors with these panel mounting 250 KOhm potentiometers ( http://bit.ly/2wOHvro ), add solid power supply ( http://bit.ly/2wOrJfY ) voltage/current monitor ( http://bit.ly/2wOrWjg ) and put everything in a nice box ( http://bit.ly/2wOHVOu )
this converter can help you in solving many power supply problems. it is able to increase or decrese the voltage at its output terminal compared to the input voltage. the output is quite stable with the load change and the multi turns trims help you in adjusting the output voltage level and the max output current as per your needs. One of the thermal pad below the MOSFET was slightly out of position, but I solved this issue very quickly - check the pads before power up the circuit. good value for money. suggested questo convertiore permette di aumentare o diminuire la tensione in uscita rispetto al valore della tensione di ingresso. la tensione di uscita è stabile rispetto alle variazioni della corrente del carico. i trim multigiri permettono una buona regolazione della tensione e della massima corrente di uscita. Un MOSFET aveva il pad termico leggermente fuori posto, ma ho risolto velocemente il problema. suggerisco un controllo dei pad termici prima di dare tensione al circuito ottimo valore per il prezzo. suggerito
Seems to work well. I will use it to have a portable power pack for all situations (recharge PC, drone Lipos, etc.). Will see how it hold up in time.
Преобразователь из низкого напряжения от 1.5 вольт может заряжать аккумулятор 12-24 вольта,правда при этом достаточно сильно греется.
I am using this to boost battery voltage to supply power into a class D amplifier. Now I can use full volume without clipping.
Works great and it doesnt heat up. Used a 12V SMPS with this and can only reach 1.1V - 29V. I hoped to reach 30V but this has the best value for buck boost converters here. 5 stars!