Kit fai-da-te per generatore di segnali di funzione Geekcreit® XR2206 Uscita sinusoidale triangolare quadrata 1HZ-1MHZ

Recensioni correlate

• Con Akbar 27/07/2021 It has some issues and it is not perfect, it has a DC offset at the output and it has very low power output capabilities. The output impedance is too high to power anything but as a basic low power signal source it is fine. I highly suggest building a current or power amplifier to go along side it to get more power. For the price it is a really good learning tool if you have an oscilloscope and since you are adjusting the function gen blindly without a scope it is not that useful. You could even use
• Con fx123 18/02/2017 PB is good quality and there is no major problem mouting it Some gotchas : * The square output is not modulated by the amplitude pot, it will always be maximum. I searched a long time for that. * The bolts are BELOW the pcb, that's why the internal screws look too short. They are just there for alignment, The PCB is hold back by the pots being sandwitched by the case (see pics, i used nylon screws but they are ~ same size as the provided ones) * you can add a led + ~ 1k resistor a tthe top of R3/R5