Una parte della recensione è stata tradotta automaticamente.
Hi. I purchased this camera mount with the aim to install it in a ZMR250. Unfortunately, it does not fit on it out of the box, but with a DREMEL, or any small similar drill, or even a small file, and a little of DIY (less than 5 minutes) you can adapt the rear holes to fin into you ZMR and the result is really good. You can see photos attached.
Can be used with a runcam 3. Edit a bit and you get 1 axe gimbal. https://youtu.be/UIvJg-X4RQU
Geht für die Runcam 2
I wanted an adjustable camera mount for my Runcam 2, since i use it as FPV camera on my builds. This mount looks like the perfect solution for that! Just make sure you build the mount as shown on the first picture below the product description, so it doesn't have the GoPro 'stoppers' in the way. I then used 2 layers of 4mm anti-vibration foam (with double-sided tape on it), which fills the spacing perfectly, and then put the Runcam 2 holder on it, for easy removal of the camera. Tied everything down with a velcro strip. I can only hope it will fit my frame (hasn't arrived yet), but can't be too hard to fix that.
I don't know how to mount mobius mini on this frame. It looks very strange and unstable
Will not fit the wizard x220 out of the package but could be modified with drilling.
good quality
#1 ! merci
Довольно тонкая пластина основания ставит под сомнение достаточную прочность. Зачем делать ложе под гопро-подобную камеру, если она туда не входит? Вот и думаешь, стоит ли ставить на такую платформу камеру за 20к.
tutto ok