Great leightweight receiver. I build a micro quad with this DSMX Pro receiver, a F4 brushed controller and reuesed parts of a defective Hubsan H107D. First I soldered the DSMX Pro receiver to UART1, because it can handle 5V. The receiecer will funtion on this port but you can not get it to bind mode. Instead of RX1 I used RX3 then. In Betaflight CLI enter: set spektrum_sat_bind=9 set spektrum_sat_bind_autoreset=0 (This is important, otherwise the save cmmand will immediately reset the bind mode) save Power cycle If motors are installed already use USB power only until all settings are done correctly! I coud bind my Devo8 with DeviationTX Software in 8CH DSMX mode. If you do not see anyting in the betaflight receiver page after binding, restore to contoller defaults and set the RX serial port and receiver and brushed settings again. Defaults will also reset spektrum_sat_bind to 0, otherwise do this step manualy to avoid binding mode ater each power cycle. The receiver works great, I did not make range test because I want to use it indoors only. Meaning of the spectrum bind modes: 3 for DSM2 1024bit/22ms 5 for DSM2 2048bit/11ms default AlienWii32 7 for DSMX 1024bit/22ms used by Devo 7e 8 for DSMX 2048bit/22ms Used by new DXe 9 for DSMX 2048bit/11ms

Great leightweight receiver. I build a micro quad with this DSMX Pro receiver, a F4 brushed controller and reuesed parts of a defective Hubsan H107D. First I soldered the DSMX Pro receiver to UART1, because it can handle 5V. The receiecer will funtion on this port but you can not get it to bind mode. Instead of RX1 I used RX3 then. In Betaflight CLI enter: set spektrum_sat_bind=9 set spektrum_sat_bind_autoreset=0 (This is important, otherwise the save cmmand will immediately reset the bind mode) save Power cycle If motors are installed already use USB power only until all settings are done correctly! I coud bind my Devo8 with DeviationTX Software in 8CH DSMX mode. If you do not see anyting in the betaflight receiver page after binding, restore to contoller defaults and set the RX serial port and receiver and brushed settings again. Defaults will also reset spektrum_sat_bind to 0, otherwise do this step manualy to avoid binding mode ater each power cycle. The receiver works great, I did not make range test because I want to use it indoors only. Meaning of the spectrum bind modes: 3 for DSM2 1024bit/22ms 5 for DSM2 2048bit/11ms default AlienWii32 7 for DSMX 1024bit/22ms used by Devo 7e 8 for DSMX 2048bit/22ms Used by new DXe 9 for DSMX 2048bit/11ms

Great leightweight receiver. I build a micro quad with this DSMX Pro receiver, a F4 brushed controller and reuesed parts of a defective Hubsan H107D. First I soldered the DSMX Pro receiver to UART1, because it can handle 5V. The receiecer will funtion on this port but you can not get it to bind mode. Instead of RX1 I used RX3 then. In Betaflight CLI enter: set spektrum_sat_bind=9 set spektrum_sat_bind_autoreset=0 (This is important, otherwise the save cmmand will immediately reset the bind mode) save Power cycle If motors are installed already use USB power only until all settings are done correctly! I coud bind my Devo8 with DeviationTX Software in 8CH DSMX mode. If you do not see anyting in the betaflight receiver page after binding, restore to contoller defaults and set the RX serial port and receiver and brushed settings again. Defaults will also reset spektrum_sat_bind to 0, otherwise do this step manualy to avoid binding mode ater each power cycle. The receiver works great, I did not make range test because I want to use it indoors only. Meaning of the spectrum bind modes: 3 for DSM2 1024bit/22ms 5 for DSM2 2048bit/11ms default AlienWii32 7 for DSMX 1024bit/22ms used by Devo 7e 8 for DSMX 2048bit/22ms Used by new DXe 9 for DSMX 2048bit/11ms

very good DSMX receiver with only 0.8g fit in all micro drones less 120mm You can use it for dustx58 to replace the FrSky with dsmx

very good DSMX receiver with only 0.8g fit in all micro drones less 120mm You can use it for dustx58 to replace the FrSky with dsmx

very good DSMX receiver with only 0.8g fit in all micro drones less 120mm You can use it for dustx58 to replace the FrSky with dsmx

WHOOP에 스펙트럼 사용자에게 정말 좋은 마이크로 수신기이다. WIREING 은 기판에 적혀있는대로 하면 되며 제품설명처럼 바인딩은 베타플라이트에서 주석을 넣고 SAVE하면 바인드모드로 들어간다. 기존에 사용하던 스펙트럼 수신기를 탈착하고 이 제품을 장착했다. 단 , 몇그램이라도 줄여야 우리의 WHOOP들은 런타임이 잘 나올것이다.

WHOOP에 스펙트럼 사용자에게 정말 좋은 마이크로 수신기이다. WIREING 은 기판에 적혀있는대로 하면 되며 제품설명처럼 바인딩은 베타플라이트에서 주석을 넣고 SAVE하면 바인드모드로 들어간다. 기존에 사용하던 스펙트럼 수신기를 탈착하고 이 제품을 장착했다. 단 , 몇그램이라도 줄여야 우리의 WHOOP들은 런타임이 잘 나올것이다.

WHOOP에 스펙트럼 사용자에게 정말 좋은 마이크로 수신기이다. WIREING 은 기판에 적혀있는대로 하면 되며 제품설명처럼 바인딩은 베타플라이트에서 주석을 넣고 SAVE하면 바인드모드로 들어간다. 기존에 사용하던 스펙트럼 수신기를 탈착하고 이 제품을 장착했다. 단 , 몇그램이라도 줄여야 우리의 WHOOP들은 런타임이 잘 나올것이다.

petit léger facile à monter et à configurer petit conseil bien faire ressortir l antenne pour éviter les faits saffe.

petit léger facile à monter et à configurer petit conseil bien faire ressortir l antenne pour éviter les faits saffe.

petit léger facile à monter et à configurer petit conseil bien faire ressortir l antenne pour éviter les faits saffe.

Man this thing is small and I can't believe the range this guy has.

Man this thing is small and I can't believe the range this guy has.

Man this thing is small and I can't believe the range this guy has.

작고 가볍고 설정하기 쉬움 5v설정이 가능해서 유용함 수신거리도 괜찮음 미니급 기체에 추천함 다시 구매함.

작고 가볍고 설정하기 쉬움 5v설정이 가능해서 유용함 수신거리도 괜찮음 미니급 기체에 추천함 다시 구매함.

작고 가볍고 설정하기 쉬움 5v설정이 가능해서 유용함 수신거리도 괜찮음 미니급 기체에 추천함 다시 구매함.

Artikel ist wie beschrieben schön klein und leicht werde ihn wieder kaufen.

Artikel ist wie beschrieben schön klein und leicht werde ihn wieder kaufen.

Artikel ist wie beschrieben schön klein und leicht werde ihn wieder kaufen.

small and light weight reciever works good

small and light weight reciever works good

small and light weight reciever works good

Good.

Good.

Good.

as described. 8 days delivery excellent.

as described. 8 days delivery excellent.

as described. 8 days delivery excellent.