Pasta per la rigenerazione del suggerimento di saldatura elettrica AT-6X
Una parte della recensione è stata tradotta automaticamente.
I previously wrote how much I liked this tip cleaner, since it was much like the RadioShack stuff that is no longer available. One drawback I discovered later was that the cleaner material is a loose powder. This works well, unless you're clumsy like me and tip your rig over from time to time. Then you have a mess. The RS stuff was a solid mass you dipped the solder tip into so was almost non-spillable. I reordered another tin of tip cleaner. This time, I took the top off, set it in a disposable aluminum pie pan, and heated it to 240 F for 2 hours. To be honest, an hour might be long enough. I ran t5he exhaust fan but noticed no odors. When the tip cleaner cooled off, it was formed into a solid mass and isn't spillable. Here are three pics of the material after it comes out of the oven, how the tip is sunk into the tip cleaner to clean it as it melts around the tip, and finally the nice clean tip that results. But it doesn't spill in this format!
Il prodotto corrisponde alla descrizione. La qualità è molto buona. Funziona in modo eccellente. L'hanno testato e sono molto soddisfatto di questo prodotto. Il prodotto è stato inserito in una confezione funzionale. Il prodotto i è altamente raccomandato.
Tökéletesen teszi a dolgát, a szennyezett, korrodélt pákahegyet korrekten megtisztítja.
ok
Very good product, to clean oxidized soldering iron tips, just dip the hot tip in the refresher and leave it there for a few seconds than the tip will be good as new.
Dopo il test vedere la foto posso concludere che soddisfa il suo scopo senza problemi. La punta calda viene pulita dai residui di stagno quando è annidata, e il resto viene asciugato su un cubo di legno.
Ottimo prodotto ha davvero ripristinato la punta. In un primo momento ho pensato che potrebbe non funzionare così grande, ma ha fatto.
Consegnato secondo l'annuncio.
Good
This is quite a small tin; 4cm in diameter. I suspect its a mix of powdered tin and flux. Directions: carefully clean your hot soldering iron tip and then push into the tining compound to form a pool. You may need to repeat this several times until the tining compund sticks to the iron tip. But does work.