Ottimo controllore di volo!

Very good flight controller!

Ottimo controllore di volo!

Sembra di buona qualità.

Looks good quality.

Sembra di buona qualità.

Sembra buono. Non ancora provato. Spedizione veloce. Grazie.

Looks good. Not tried yet. Fast shipping. Thanks.

Sembra buono. Non ancora provato. Spedizione veloce. Grazie.

Bello FC con aggiunta di baro e flash per blackbox, un sacco di uarts disponibili e fori essenziali nel PCB per filettare i fili prima della saldatura che rende molto più facile ottenere cablato. Ha un pin dedicato sul TX5 per GPS e funziona anche con l'unità d'aria Caddix/DJI. Grande piccola replica pin fuori PCB inviato pure con tutti i pin etichettati che è sia utile e fare un portachiavi decente aggiunta in seguito. Ne hanno usati due finora e probabilmente ne compreranno un altro per sostituire gli FCS di fascia bassa con qualcosa di molto, molto meglio. L'unica delusione è nessun firmware INAV posso vedere per questo ancora che lo renderebbe un piccolo compagno molto completo! Anche avere a dare un grido a jemchu(?) 20 scheda esc con gli stessi fori per filettatura filo

Nice FC with addition of baro and flash for blackbox, lots of uarts available and essential holes in PCB to thread wires before soldering which makes it sooooo much easier to get wired up. Has a dedicated pin out on TX5 for GPS and works with Caddix/DJI air unit as well. Great little replica pin out PCB sent as well with all pins labelled that's both useful and make a decent keyring addition afterwards. Have used two so far and will likely buy another to replace basic tyro low end fcs with something much, much better. Only disappointment is no INAV firmware I can see for this yet which would make it a very complete little fellow! Also have to give a shout out to jemchu(?) 20 esc board with same holes for wire threading

Bello FC con aggiunta di baro e flash per blackbox, un sacco di uarts disponibili e fori essenziali nel PCB per filettare i fili prima della saldatura che rende molto più facile ottenere cablato. Ha un pin dedicato sul TX5 per GPS e funziona anche con l'unità d'aria Caddix/DJI. Grande piccola replica pin fuori PCB inviato pure con tutti i pin etichettati che è sia utile e fare un portachiavi decente aggiunta in seguito. Ne hanno usati due finora e probabilmente ne compreranno un altro per sostituire gli FCS di fascia bassa con qualcosa di molto, molto meglio. L'unica delusione è nessun firmware INAV posso vedere per questo ancora che lo renderebbe un piccolo compagno molto completo! Anche avere a dare un grido a jemchu(?) 20 scheda esc con gli stessi fori per filettatura filo

schnell geliefert, gute Qualität.

schnell geliefert, gute Qualität.

schnell geliefert, gute Qualität.

This could be the best flight controller,, but... 1) The BOOT button did not work for me (The device was not even listing in the devices in windows) -I have investigated this and fiound out that the button must pull BOOT0 pin of the MCU to VDD, but when the FC is connected to the usb, there is no 3.3v on the other side of the button. 2) There is no INAV build for this FC. -I have tried the one for MATEKF405-SE and it bricked my Baro. (Actually, the rest was working not sure if UARTS are in the right order as on PCB) 3) After I have reflashed to BF, the baro is not working anymore. 4) The support chat of the facebook group of SKYSTARS answers to do the things that i have already did despite that i have descrbed the problem and I am not a total newbie. 5) SKYSTARS website downloads page leads to nowhere so they even not giving pin definitions or a complete BF build for the FC. Overall it is very very very good quality soldered pcb, it is nice and tiny, it has baro and many uarts. It could have been the best flight controller for the price.

This could be the best flight controller,, but... 1) The BOOT button did not work for me (The device was not even listing in the devices in windows) -I have investigated this and fiound out that the button must pull BOOT0 pin of the MCU to VDD, but when the FC is connected to the usb, there is no 3.3v on the other side of the button. 2) There is no INAV build for this FC. -I have tried the one for MATEKF405-SE and it bricked my Baro. (Actually, the rest was working not sure if UARTS are in the right order as on PCB) 3) After I have reflashed to BF, the baro is not working anymore. 4) The support chat of the facebook group of SKYSTARS answers to do the things that i have already did despite that i have descrbed the problem and I am not a total newbie. 5) SKYSTARS website downloads page leads to nowhere so they even not giving pin definitions or a complete BF build for the FC. Overall it is very very very good quality soldered pcb, it is nice and tiny, it has baro and many uarts. It could have been the best flight controller for the price.

This could be the best flight controller,, but... 1) The BOOT button did not work for me (The device was not even listing in the devices in windows) -I have investigated this and fiound out that the button must pull BOOT0 pin of the MCU to VDD, but when the FC is connected to the usb, there is no 3.3v on the other side of the button. 2) There is no INAV build for this FC. -I have tried the one for MATEKF405-SE and it bricked my Baro. (Actually, the rest was working not sure if UARTS are in the right order as on PCB) 3) After I have reflashed to BF, the baro is not working anymore. 4) The support chat of the facebook group of SKYSTARS answers to do the things that i have already did despite that i have descrbed the problem and I am not a total newbie. 5) SKYSTARS website downloads page leads to nowhere so they even not giving pin definitions or a complete BF build for the FC. Overall it is very very very good quality soldered pcb, it is nice and tiny, it has baro and many uarts. It could have been the best flight controller for the price.

Che fantastico piccolo FC il 10volt bec è molto utile con il serbatoio Rush mini. Super felice.

What an awesome little FC the 10volt bec is very helpful with the Rush tank mini. Very clean no noise on the VTX. Super happy.

Che fantastico piccolo FC il 10volt bec è molto utile con il serbatoio Rush mini. Super felice.